|
|
|
Here's a few images of the targets getting replaced and the top of the new PF as well. I started the top side of the PF swap just because I was on a roll today and just wanted to keep on going so I started to do the bottom half of the PF. One thing I forgot to say earlier was that by having the side rails installed early in the swap I was able to drop all the bulls-eye and slingshot switches and these drop targets straight down in their holes when re-installing them on the underside of the PF and screw them back into place easily with the new PF upside down on my table, so that was also a good idea.
I had found images of the Targets for Time warp years ago on the net, they were a little untidy so I "nudged them up a bit" in Photoshop and then printed them onto a gloss card thickness paper and covered them with a clear contact film like Mylar for protection. If you have a Time Warp and need the images email me and I will send you a printable sheet of all 8 targets - see how they came out below
This is as far as I got today, I did get all the lower half back together and the flippers set in place as well. At the time of this PF swap I had no blue rubbers so I painted the flippers, I have since found NOS blue rubbers and installed them. I have the apron off and I have re-sprayed it and I am working on the cards right now, that will be put back in place soon.
As you can see- it will all be worth the effort in the end, eventually I hope to have enough space to show you the apron and cabinet all re-done as well. I am currently working on getting the cabinet artwork reproduced as a "sticker stencil" that I can just lay over my crappy Time Warp cabinet , like I did with my Black Knight.
|
|
|
